Victron MultiPlus-II 48/3000/35-32 230V

A maximum grid or generator current can be set on the Multiplus-II 48/3000/35-32. The MultiPlus-II then takes into account other connected AC consumers and only uses the current that is still 'left over' to charge the battery. This prevents the generator or grid connection from being overloaded (PowerControl function). With the PowerAssist function, the PowerControl principle gains a new dimension. Power peaks often occur only for a limited period of time. In such cases, the MultiPlus-II immediately compensates for insufficient generator, shore power, or grid power by drawing energy from the battery. When the load is reduced, i.e., when consumers are switched off, the energy that is then sufficiently available can be used to charge the batteries again.

The device can be used with both off-grid and grid-connected PV systems as well as with other alternative energy systems. It can be used with both solar charge controllers and grid-tied inverters.

The main output ensures uninterrupted operation. In the event of a power failure or an interruption of shore/generator power, the MultiPlus-II takes over the supply to the connected loads. The switchover happens so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices is guaranteed. The second output only supplies power when AC is available at the input of the MultiPlus-II. Loads that must not discharge the battery, such as a water heater, can be connected to this output.

many options for system expansion

Install a Color Control GX or other GX products to connect to the internet. The operating data can be stored and viewed free of charge on our VRM (Victron Remote Management) website. If systems are connected to the internet, they can be accessed remotely and settings can be changed.